![θP](../../maintenance/change the base tape/image002.jpg) |
![θQ](../../maintenance/change the base tape/image004.jpg) |
![θR](../../maintenance/change the base tape/image006.jpg) |
@
Remove the seal wire holder. |
A
Take off dirty base tape. |
B
Clean or wipe alcohol or thinner etc. |
![θS](../../maintenance/change the base tape/image008.jpg) |
![θT](../../maintenance/change the base tape/image010.jpg) |
![θU](../../maintenance/change the base tape/image012.jpg) |
C
Wipe the surface of seal bar before set the base
tape. |
D
Set the base tape stretching carefully (2 sheets). |
E
Two sheets of base tape should be set moving
respectively. |
![θV](../../maintenance/change the base tape/image014.jpg) |
![θW](../../maintenance/change the base tape/image016.jpg) |
![θX](../../maintenance/change the base tape/image018.jpg) |
F
Cut the tape at necessary point to avoid take-off
from bending part. |
G
End of the tape should be bent. |
H
Put insulation plate upon the seal wire holder. |
![θPO](../../maintenance/change the base tape/image019.jpg) |
![θPP](../../maintenance/change the base tape/image021.jpg) |
I
Set the screw temporary. |
J
Adjust the tape position, confirm suitable setting
and then tighten the screw firmly. |